UVIWAX UV-PROTECTION UNIQUE NON-YELLOWING UV-PROTECTION UV-resistant and non-yellowing Water and dirt resistant Saliva-resistant and sweatproof, suitable for children’s toys Microporous, breathable finish which does not crack, peel or flake No sanding necessary for spot repairs or future applications SURFACE PREPARATION Wood surface must be clean, dry and frost-free (moisture content max. 18%, coating temperature at least +10°C). Osmo Uviwax UV-Protection is ready to use. Do not thin. Stir well before use. Clean old microporous stains thoroughly. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works. Degrease very resinous woods (e.g. Larch) with Osmo Brush Cleaner and Thinner. Osmo Uviwax UV-Protection is to be used alone and solely applied to raw wood. If necessary, sand wood again with fine sandpaper. Wood treated with Osmo Uviwax UV-Protection generally only need to be cleaned and recoated. The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces. METHOD OF APPLICATION With Osmo Flat Brush apply thinly, quickly and evenly along the wood grain and spread well, or use a spray coating method. Allow to dry for approx. 3-4 hours under good ventilation. If necessary, sand surface with fine sandpaper (grit P360) before applying the second coat. After drying, apply a second coat also thinly and quickly. For renovation works, one coat applied to the clean and dry surface is usually sufficient. NOTE Uviwax UV-Protection is to be used alone. Please do not dilute or mix with other finishes. If a surface treated with Uviwax UV-Protection should be recoated in a different colour, we solely recommend using Osmo Interior Wax. Using general or multi-purpose cleaners will increase the frequency of maintenance and recoating. Allow finish to fully cure before