BRANDED - SUNHOUSE (DIMPLEX GROUP) Brackets are included with the heater for wall or floor mounting The heater is fitted with approximately 1.5m cable and a standard 3 Pin UK Plug TUBULAR HEATER: This tubular heater will provide a safe, low level of heat output as it is designed for continuous operation and will reach normal operating temperatures within a few minutes after the appliance is switched on. Based on the surrounding environment and ambient temperature, the heater may periodically cycle its heat output to ensure the maximum permitted surface temperature is not exceeded. All models are splash proof to IPX4 standard. The ends of the unit are a light brown colour DIMENSIONS 3ft - 1020mm THERMOSTAT INFORMATION: The heater is fitted with an adjustable thermostat which allows the user to control the heat output. In order to maintain a certain room temperature, set the controller to the maximum setting. Operate the appliance at full power until the required room temperature is reached. Set back the thermostatic controller until the appliance switches off with an audible ‘click’. This temperature will be kept almost constant by the thermostatic control switching on and off automatically. Please note that the appliance can only be switched on when the thermostat setting is higher than the room temperature. At its lowest setting the heater will provide a level of protection against frost. PROTECTIVE WIRE GUARD: Specifically designed for the Longer Tubular Heaters that Incorporate a Stat Supplied with Separate Moveable P-Clips. The clips can be placed anywhere on the frame for ease of installation in confined or awkward spaces. The open wire mesh construction allows Optimum Heat Circulation Made from Steel Weld Mesh on a Steel Frame which means the guard is strong yet compact. The Surface Temperature of the Guard Stays Safe to Touch. Approximate Guard Dimensions: 3ft - 1018mm long x 137mm wide x 114mm deep